Starting an inboard boat engine out of water is not as challenging as it may seem, but there are a few things you need to keep in mind to ensure a smooth start. Here are a few things to consider when trying to start an inboard boat engine out of water.
1. Check the Fuel and Oil Levels
Before attempting to start the engine, make sure you have enough fuel and oil levels. Check the fuel tank and top off if necessary. Also, check the oil levels using the dipstick to ensure the engine has enough lubrication.
2. Turn off All Electrical Devices
Turning off all electrical devices, including radios, GPS systems, and lights, can help minimize the amount of power required to start the engine. This can help reduce the load on the battery and allow the engine to start more smoothly.
3. Prime the Engine
If the engine hasn’t been started for a while, you may need to prime it before attempting to start it. You can do this by opening the fuel shut-off valve and pressing the primer button several times until fuel reaches the carburetor.
4. Connect a Flusher
One of the essential things you will need when starting an inboard boat engine out of water is a flusher. The flusher should be connected to the water intake found at the bottom of the boat. The flusher will ensure that water circulates through the engine and cools the engine down as it runs.
5. Turn on the Engine
Once everything is set and ready to go, turn the key to the “on” position, then turn the key to the “start” position. Wait for the engine to start and run smoothly. Once started, allow the engine to run for a few minutes before turning it off.
Starting an inboard boat engine out of water requires a few precautions and a little bit of knowledge. By following these five steps, you can start your inboard boat engine out of the water with ease. Always remember to check the fuel and oil levels, turn off all electrical devices, prime the engine, connect a flusher, and turn on the engine. With these steps, you’ll be able to enjoy a smooth sailing experience.